Programación funciones del Kenwood TS-450

  

Descarga manual del Kenwood TS-450s desde la zona de descargas: PINCHA AQUÍ

FUNCIÓN COMBINACIÓN DE TECLAS DESCRIPCIÓN
MASTER RESET A=B + Power ON Microprocessor RESET
VFO RESET A/B + Power ON VFO RESET save MEM Chan
Características 01 – 21 LSB/USB + Power ON Setup para Características 01 – 21
Características 31 – 42 M.IN + Power ON Setup para Características 31 – 42
Filter Sel/Ext Tuner ENT + Power ON Selects Installed Filters/Tuner(1)
Exit Program Modes CLR Exits Program Modes
Basic Function Select number 2 + Power ON Limit operational features
Full Function Select number 1 + Power ON Allow all operational features

Características 01 – 21
CARACTERÍSTICA Valor   CARACTERÍSTICA valor
01 – Main Tuning ON/OFF   11 – NB2 ON/OFF
02 – Zero Lower Digit ON/OFF   12 – Mem Split Freq ON/OFF
03 – Numeric Keypad ON/OFF   13 – Auto mem chan Inc ON/OFF
04 – Beep ON/OFF   14 – Mem chan tunable ON=Adj, OFF=Fixed
05 – Mode Announce ON=Morse, OFF=Beep   15 – Scan Hold ON/OFF
06 – Error Announce ON=Morse, OFF=Beep   16 – Linear Key Relay ON/OFF
07 – 10Hz Display ON/OFF   17 – Data Xfer ON/OFF
08 – Meter Peak Hold ON/OFF   18 – Data Rx Select ON=VFO, OFF=Chan 0
09 – Save Band Freq ON/OFF   19 – Transmit ON/OFF
10 – SSB Auto Select ON/OFF   20 – Prevent chan erase ON/OFF
      21 – Mem Chan Protect ON/OFF

Características 31 – 42
CARACTERÍSTICA VALOR   CARACTERÍSTICA VALOR
31 – Auto Ant Tuner ON/OFF   37 – FSK Shift 170, 200, 425, 850 Hz
32 – Ret to rx after tune ON/OFF   38 – FSK Key Sense ON=Space, OFF=Mark
33 – Freq/Turn Main 5 KHz, 10 KHz   39 – FSK RX Tone 1275, 2125 Hz
34 – Freq Step VFO CH 1, 2, 5, 10 KHz   40 – CW Pitch/Offset 400 – 800 Hz (50 Hz)
35 – MW Band Step 9 KHz, 10 KHz   41 – RIT/XIT Range 1.1 KHz, 2.2 KHz
36 – 1MHz Key 500 KHz, 1000 KHz   42 – Power On HELLO ON/OFF

(1)Filtros opcionales y sintonizador de antena externa
CARACTERÍSTICAS VALOR
01 – External Antenna Tuner ON/OFF
02 – 8.83 MHz SSB Filter ON/OFF
03 – 8.83 MHz CW Filter ON/OFF
04 – 455 KHz CW Filter ON/OFF

Abrir TX y RX:  pulsar teclas CLR+ENT + POWER ON, en recepción llega a 40 MHz, y en TX de 7 a 7500 MHz.

Características en Rigpix